NEIEP 800 FINAL EXAM QUESTIONS
AND ANSWERS 100% CORRECT
Question : Hydro elevators in low rise applications do not
need an _____ _____ room.
Correct answer: overhead machine
Question : Some advantages of hydros are lower equipment
and building construction costs because the load of a hydro is carried to the _____ where as the load of a traction car is carried by the _____ _____.
Correct answer: ground, building structure
Question : When drilling the jack hole, the only proper way to
determine if the hole is plumb is to remove the drill stem and bit and use a _____ _____.
Correct answer: Spider Bob
Question : To plumb the hole, a spider bob is attached to a
length of piano wire suspended from as near as possible to the top of the _____ or from a fixed point on the drill rig.
Correct answer: Hoistway
Question : When welding a joint, lay _____ inch tack welds
_____ degrees apart, shift it 90 degrees and lay two more 1 inch tack welds 180 degrees apart.
Correct answer: 1, 180
Question : On power units having the motor beneath the tank,
the pump may be either _____ driven or _____ coupled.
Correct answer: belt, direct
Question : The purpose of the / is to silence the effect of any
pulsations in the pump output and should be as close to the pump as possible.
Correct answer: silencer, muffler
Question : On Bolsters/Bolster Assembly, the plunger is
fastened to the _____ _____ which is then mounted to the center of the Bolster Assembly.
Correct answer: platen plate
Question : With wye-delta, reduced current starting is
accomplished without the need for _____.
Correct answer: resistors
Question : _____ run buttons should run the platform and
sling at leveling speeds only.
Correct answer: Temporary
Question : A _____ _____ consists of a piston held closed by
an adjustable spring and must open at a certain pressure to prevent any further increase in pressure.
Correct answer: relief valve
Question : A _____ lowering valve allows the car to be
lowered at a speed not exceeding 20fpm in case of power failure.
Correct answer: manual
Question : As the oil temperature changes, the _____ will
change as well and will effect the performance, more specifically, the leveling and approach of the elevator.
Correct answer: viscosity
Question : Be sure wellways are properly _____ to avoid
accidental injury to you, your team or anyone working outside of our industry.
Correct answer: barricaded
Question : Barricades around the wellway must be _____
inches high and be capable of withstanding a _____lb force.
Correct answer: 42, 200
Question : A _____ protects you if you come in contact with a
hot wire or component and then come in contact with ground.It opens the circuit and diverts the supplied current to ground.
